Flagpole installation acrossArkansas

Flagpoles in Arkansas

Ozark hill towns, Delta farm country and the state capital sitting between them.

Wind here. Arkansas barely moves on the wind map. Eder's wind map puts Lake Village in the southeast corner, Little Rock in the middle and the Missouri line above Rogers all in the same 90 mph zone, so a shaft that suits a courthouse in one county suits one three hundred miles away. Two other things decide the job instead. The first is ice. The code map puts roughly 1.5 inches of ice all round a pole across the centre, the south and the Delta, and roughly 2 inches over the Ozarks and the western river valley, and a flagpole is one of the structures the code names as ice-sensitive, so the hardware at the top earns more attention here than the wall thickness does. The second is the ground, which changes completely from one corner of the state to the next — wind-blown loess and river silt out in the Delta, limestone full of solution holes under the Ozarks, and novaculite in the Ouachitas, a rock hard enough to blunt ordinary drilling.

• The Delta and the Mississippi flood plain — 90 mph on Eder's map over flat rice and cotton ground with nothing upwind of it for miles. The figure is gentle and the ground is not. Backwater sits close to the surface out here, and a footing poured into saturated silt has to spread wider than the height on its own would ask for.
• Central Arkansas and the Fall Line — Still 90 mph through Little Rock, Conway and Pine Bluff. Wind rarely sets the shaft here. What sets the foundation is which side of the Fall Line an address falls on: hard rock to the west of it, coastal plain sand and clay to the east.
• The Ouachitas and the southwest — 90 mph again, and the wind is the easy part. Shale, chert and novaculite under Hot Springs, Malvern and Mena turn a straightforward hole into rock work, and that is where the money actually goes.
• The Ozarks, the river valley and Northwest Arkansas — 90 mph on Eder's map, with the heaviest ice figures in the state on top of it: roughly 2 inches all round the shaft, from Rogers and Fayetteville down through Fort Smith and Russellville. That is real weight hanging on a flag and on the rope that carries it, so stainless hardware and a rope run inside the pole are worth the difference.

Flying the Arkansas flag? We sell it, sewn to the state's own design specification and sized to sit under the national flag on your pole. See the Arkansas flag →

Need taller than 80 ft? We supply steel flagpoles from 100 to 150 ft, made in the USA, for car dealerships, truck stops and other big sites across Arkansas. 100–150 ft flagpoles in Arkansas →